SLE Cladding Limited

For further information please contact SLE Cladding Ltd. Tel. 01948 666 321. Fax. 01948 66 55 32

F.A.I.R.S ORDERING or QUOTATION REQUEST INSTRUCTIONS

If in the slightest doubt over the following information and form, do consult the SLE Sales Office.

To enable you to supply our staff with the information required to provide a quotation or process an order, we have reproduced the F.A.I.Rs manufacturer's order form. You may require the instructions below to help you understand the order form, so it is as well to print them off before printing off the form.

Should the drawings on the "Order Form" appear or printout unsatisfactory, click on any of the 3 drawings on the form. Enlarged drawings will appear which may also be printed off.
		To go to the Order Form.

INFORMATION REQUIRED TO MANUFACTURE ORDERS. Name, depth and coverwidth of profiled top outer sheet. What class of fire rating is required for the top sheet ? Class O, Class 1, Class 2 or Class 3 What class of fire rating is required for bottom sheet? Class O, Class 1, Class 2 or Class 3 Length of Sheet. (A) Viewed from the eaves, are the FAIR's to be laid from right to left or from left to right? and how many of each. Cut back (C) required at end of FAIR's to facilitate overlap of next sheet or at eaves to provide overlap of gutter. Depth of insulation required. (E) On each size of FAIR's, the number of purlins to be spanned. A single span is 2, a double span is 3 and a triple span is 4 etc. Distance between purlin centres. (B) These centres may vary, check them all. Top Lap. (D). Not usually required.
IMPORTANT. On entering the Order Form to request a quotation or place an order you will be faced with a wide choice of sheet materials, thicknesses and insulation values from which to construct your F.A.I.Rs. SLE Cladding Ltd are cladding merchants and as such sales staff are not qualified to advise on these products and on insulation values. If your requirements (as are most requirements) are just for the basic, standard lowest cost F.A.I.Rs, just tick the pink boxes in the materials sections and provide the required measurements. Persons enquiring or ordering the higher specification products will be presumed by our staff to have the necessary qualifications and knowledge in that field and to instruct them accordingly.
		To go to the Order Form.